Morning for Washington (not DC),

 

Using CT Striker Book 3 I, hopefully if I correctly followed the directions, worked out the specifications for the 80 mm and 120 mm rockets on MT COACC p. 69.

 

CT Striker Book 3 Design Sequence 9 TAC Missiles pp. 21-22 and pp. Design Sequence 2: CPR Guns L. Ammunition pp. 14-16

 

80 mm HE Rocket (Tech Level 7)

Contact Pen = 14; Ground Burst Size = 2; Air Burst Size = 4; Fragmentation Pen = 2

Weight = 1.4 kg; Volume = 0.0021 m^3; Price: Cr 6.3

 

80 mm Flechette Rocket (Tech Level 7)

Contact Pen = 2; Hit DM = 0; Danger = 5 cm

Weight = 1.4 kg; Volume = 0.0021 m^3; Price: Cr 28.7

 

120 mm HE Rocket (Tech Level 7)

Contact Pen = 19; Ground Burst Size = 3; Air Burst Size = 6; Fragmentation Pen = 3

Weight = 4 kg; Volume = 0.006 m^3; Price: Cr 18

 

120 mm Flechette Rocket (Tech Level 7)

Contact Pen = 2; Hit DM = +1; Danger = 5 cm

Weight = 4 kg; Volume = 0.006 m^3; Price: Cr 82

 

1. Looking at the MT Specifications for the missiles my CT HE contact penetration is on target for the 80 mm HE rocket but the 120 mm contact penetration is 19 versus 18. Unfortunately my calculations for the 80 mm and 120 mm Flechette rockets penetration are off. If I made the Flechette warhead TL 10 my CT 80 mm penetration would match, but would be off by 1 for the 120 mm warhead.

 

For the 120 mm HE rocket I thinking that the contact penetration should be bumped up from 18 to 19. Does this sound right and should I note the difference as errata?

 

The Flechette warheads I’m not sure what to do with. I have incomplete TNE FF&S spreadsheet and one for BTRC 3G^3 that has a conversion system for MT, TNE, and T4. Should I try finishing them up to see how the two systems work out the rockets specifications?

 

2.MT COACC Damage I have not figured out how to calculate using CT Striker. Does anyone have an idea of how to figure this out and can you please let me know to do the math?

 

3. CT Striker does not indicate that a HE warhead has a danger space, while the Flechette warheads’  danger spaces are 5 cm.

 

Looking at the MT COACC Danger specifications the 80 mm Flechette‘s danger space appears to be for a CT medium velocity round’s of 10 x 10 = 100 and the 120 mm Flechette‘s danger space is a CT high velocity round’s of 15 x 10 = 150.

 

Can anyone please let me know how the HE danger space was determined?

Any suggestions on handling the Flechette danger space?

 

4. Weight, Volume, and Price

 

From what I’ve found so far CT Striker’s rockets may be smaller than most real world examples. In my opinion the prices are probably low too.

 

I’m not sure what to do about the weight and volume, does anyone have a suggestion or should I let them be as determined in CT Striker?

 

Does increasing the price by 10 sound reasonable or should I let them be as determined in Ct Striker?

 

Tom Rux